|
  |
You have just purchased the finest vinyl sundeck waterproofing system available on today's market. It has been installed by a fully trained, licensed dealer using special tools,
adhesives, hardware and caulkings that have all proven to be not only highly compatible with the vinyl system, but also are the best available for the job. To maximize the life of your new WEATHERDEK vinyl sundeck,
here are a few simple tips on how to clean and maintain the vinyl.
You should clean the vinyl surface regularly, using a mild soap and water solution (common dish soaps are fine). If the area is particularly dirty, use a stiff
bristle push broom and scrub with a circular motion. This will loosen up the dirt at the bottom of the textured pattern so it can be sprayed away with a hose. Light pressure washing of the vinyl surface is also
acceptable but care should be taken when spraying near heat welded seams and sealant caulked areas.
Warning
Never let vegetable matter such as leaves lay on the deck surface for long periods of time. Their stains can be very hard to remove.
Special
There are often situations where stronger cleaning solutions are necessary. Spray cleaners like "Fantastic" or "409" can be used on oil, grease or wet paint spills, but continuous use
will break down the top coat finish and is not covered under warranty. Neoprene glue can be softened and removed with ether (cold weather automobile starter fluid). Difficult vegetable stains may require diluted bleach or diluted
trisodium phosphate and lime stains from mortar joints or stucco siding can be removed with diluted muriatic acid.
Warning
No matter what the solution being used to clean your vinyl surface, it should only be briefly applied. Test it first on a piece of scrap vinyl to be sure it will not remove the colour
or otherwise affect the membrane. Most importantly, flush the area thoroughly with soap and water then rinse with water only to completely remove any residue. Under no circumstances are any acids, Ketones, Turpentine, solvents or
other unnamed chemicals to be used. They will affect the finish and will not be covered by the warranty.
Inspection
The only maintenance, other than cleaning, is to inspect the caulking used to seal around posts, pillars, corners, vents and drains. Sometimes the wooden structure to which the vinyl
is sealed, cracks or shifts, and the seal is broken. Yearly inspection will uncover such problems and Calgary Weatherdek can supply the proper caulkings to fix the problem.
If you have any further questions, do not hesitate to contact Calgary Weatherdek at 287-2002.
|
|